Skip to main content
مستورد رسمي وعلامات تجارية معتمدة

Free diagnostic guide

Concrete Damage Diagnostic Assistant

This tool is limited to the official waterproofing and primer products used in the scenarios covered by the technical sheets.

Swimming pools and drinking water tanks, underground water pressure, and substrate uncertainty should still be reviewed before final material ordering.

Recommends only SE 980, PR 008, PR 005, and PR 007
Shows timing rules from the datasheets
Adds area-based SE 980 takeoff when the area is known

Describe the condition

Choose the visible symptom or preparation case, the location, severity, and any exposure conditions. Area is optional but lets the tool calculate SE 980 quantity guidance.

Visible symptoms or preparation case

Choose every symptom or preparation condition that clearly applies.

Location
Severity
Exposure conditions

Exposure helps separate standard waterproofing from negative pressure and higher-risk conditions.

Extent
m²
The result explains the likely condition, the right product, the timing rule, and whether technical review is needed.

Concrete repair FAQ

Swimming pools and drinking water tanks, underground water pressure, and substrate uncertainty should still be reviewed before final material ordering.

When is SE 980 used?

Use SE 980 for wet rooms, tanks, foundations, and water penetration through walls or floors. It is applied in 2 coats for standard waterproofing and 3 coats for reservoirs.

When is PR 008 used?

Use PR 008 before tiling on gypsum block, gypsum plaster, or gypsum-based backgrounds. Wait at least 6 hours before the next layer.

What is the difference between PR 005 and PR 007?

PR 005 is a ready-to-use liquid primer for existing non-absorbent tiles. PR 007 is a powder primer used for existing tiles, mesh-backed stone, XPS boards, and other renovation surfaces.

Can SE 980 be used against negative pressure?

Yes. SE 980 is suitable for negative waterproofing and withstands 1.5 atm negative pressure for 24 hours.