Bathroom & Plumbing Accessories — Installation Guide 2026 | ramo.co.il

Before any plumbing work, prepare: Teflon tape 13 mm — 2-3 wraps for standard connections. Plastic tap 3/4 inch for main garden water line. Ceramic cartridge head 40 mm to replace a dripping tap cartridge. Chrome cover 10×10 cm to cover exposed pipe ends after renovation. Inspection box elevation 110 mm to raise the cover after tiling.

1. Seal with teflon tape: Wrap Teflon tape 13 mm clockwise around the male thread — 2-3 wraps for small connections, 4-5 for larger ones. 2. Replace a faulty tap: Shut off main supply → release pressure via another tap → thread the Plastic tap 3/4 inch with teflon → tighten firmly but not excessively. 3. Replace cartridge: Remove decorative cap, unscrew centre bolt, swap in Ceramic cartridge 40 mm — fits most standard taps. 4. Install drain seal: Place the 110 mm seal over the drain pipe, ensure tight contact with pipe edge. 5. Elevation after tiling: After adding a tile layer, use 110 mm elevation to bring the cover flush with the new floor. 6. Cover exposed pipe ends: Press chrome cover firmly against the wall over the pipe end. 7. Leak test: Turn on main supply slowly, wait 5 minutes, check every connection by hand.