⚡
Quick Summary
SP Industries 90° elbow allows easy pipe direction changes.
3/4' elbow price: ₪30.75 incl. VAT.
SP double nipple: ₪10.28 incl. VAT.
Sometimes plumbing needs to turn a corner – that's exactly what the 90° elbow is for.
SP Industries offers quality elbows for all pipe diameters, and in this guide you'll learn how to install one yourself.
What is a 90° Elbow and When to Use It?
A 90° elbow is a fitting that allows a pipe to make a sharp turn.
Used when you need to:
- Turn from vertical to horizontal pipe
- Route around an obstacle
- Connect a wall faucet to a floor pipe
What You'll Need
✅ SP 90° elbow 3/4' – ₪30.75 incl. VAT
✅ SP double nipple – ₪10.28 incl. VAT
✅ SP bushing nut 16x1/2 – ₪17.79 incl. VAT
✅ PTFE tape and adjustable wrench
Assembly Steps
- Close main water supply.
- Remove the old pipe at the connection point.
- Apply PTFE tape on each male thread – 3 clockwise wraps.
- Thread the double nipple into the elbow inlet – tighten with wrench.
- Thread the elbow in the correct direction – verify direction before final tightening.
- Connect the continuing pipe and check for seal.
⚖️SP Elbow Advantages
✅Advantages
- •Quality brass – sealed and durable
- •Fits common 3/4' pipes
- •Easy DIY assembly
- •Long service life
❌Limitations
- •Not suitable for pressure over 10 bar
- •Must verify direction before final tightening
❓
Frequently Asked Questions
Is SP elbow suitable for both hot and cold water?
Yes, SP elbows are certified for use with hot and cold water up to 90°C.
What's the difference between 1/2' and 3/4'?
3/4' is for main lines, 1/2' for branches and faucets.
How much does an SP 90° elbow cost?
₪30.75 incl. VAT for the 3/4' elbow.