How to Install Wall Hooks and Shelves — Step-by-Step Guide 2026 | ramo.co.il

Gather the following before you begin:

Your chosen hook — nickel hook, aluminum hook, bronze hook, or FIX adhesive hook
Drill — for concrete or brick walls only
Concrete drill bits (6–8 mm diameter) — for concrete walls
Wall plugs and screws — plastic plug 6 mm for concrete, expanding plug for drywall
Spirit level — to ensure straightness
Pencil — to mark position
70% alcohol — to clean the surface before adhesive hooks

For FIX adhesive hooks — no drilling required at all.

Step 1 — Mark the position: Use pencil and spirit level to mark your installation point. Coat hook: 160–180 cm from floor. Bathroom hook: 120–140 cm.

Step 2 — Check for hidden utilities: Before drilling, run a multi-detector over the wall area. Confirm no electrical wires, water pipes, or gas lines are present.

Step 3 — Choose installation type based on wall:
• Concrete/brick wall: Drill 6 mm hole, insert plastic plug, place hook and screw in.
• Drywall: Use expanding drywall plug — insert into 6–8 mm hole and twist until it expands behind the board.
• FIX adhesive hook: Clean wall with alcohol, dry completely, remove backing paper, press firmly for 60 seconds.

Step 4 — Insert plug (drilled installations only): Push plug into hole until flush with wall. Don't hammer too hard — plug may split.

Step 5 — Screw in the hook: Hold hook in place and screw in (hand screwdriver or low-speed electric). Tighten until stable — don't overtighten.

Step 6 — Test stability: Pull hook gently in several directions. Wobbling? Remove, use a larger plug, try again. Adhesive hook — wait 24 hours before adding any load.